If you installed an ice barrier, the felt paper goes on top of that; otherwise, it Roofing Company Near Me goes directly on the decking. Paper, or I plan to leave the paper exposed for more than a few days. Heavier paper wrinkles less and is less likely to tear when someone walks on it. On warm days, self-stick underlayment will stick to clean decking without fasteners.

Installing a TPO roof involves several steps, from roof preparation Nema Roofing and insulation to membrane installation, seaming, and flashing. By following this step-by-step guide, you can ensure that your TPO roof is installed correctly, providing your building with a durable and energy-efficient roofing solution. Wagler Steel is your trusted partner for all your metal roofing and metal siding needs. We offer a wide variety of durable, high-quality panels designed to suit any project. In addition to our wide range of panel styles, our panels come in a plethora of colors and finishes, and can be delivered directly to your job site.

Will Your Warranty Cover Installation Mistakes?

When you get all your shingles installed up to the point of the roof, you’ll need to install a ridge cap. The ridge cap is installed with shingles going the opposite way, so they lay over the cap of the roof. This creates a tight seal that allows for water and ice to go down either side of the roof, rather than sitting on top and leaking through where the two peaks meet.

This lifespan often surpasses that of single-ply roofing options, especially in demanding climates. In this guide, we’ll walk you through each step of the BUR installation process, explain its key components, and highlight what to expect from a qualified contractor. Clay roofing boasts an impressive natural aesthetic, versatility, and longevity of up to 100 years. Storm Guard specializes in high-quality clay tile installation, guaranteeing durability against the local climate while preserving its appeal. This underlayment layer is sticky and should adhere to the sheathing. In cold climates it goes around the edges of your roof, with special attention to the very bottom edge since it’s most prone to ice damming and water buildup.

Ignoring Manufacturer Guidelines:

Peel back part of the uppermost backing on the roll, and nail the top corner of the underlayment to the decking. Start pulling the roll across the decking using the backing, ensuring the material is as flat and as straight as possible as you pull. The most efficient tear-off procedure is to pry off the ridge cap shingles with a pry bar and then transition to a roofing tear-off shovel for the rest.

Remember, the cheapest option isn’t always the best—prioritize quality and reliability. Continue installing panels horizontally, ensuring each one overlaps the previous panel according to the manufacturer’s instructions. Measure your roof area carefully, adding 10%–15% extra material to account for waste and mistakes. We’re the locally preferred roofing team in Fort Colins, Laramie, and beyond.

Preparing For Roof Installation

The other side of the roof should be completed in the same way as the first side. You cannot cap the roof with the roof ridge until both sides are complete. Like-in-kind roofing, where sheathing is not removed, may not require a permit. Re-roofing may require a permit due to the increased static load on the roof. Rolloff dumpsters parked on the public street usually require permits. For more information or to schedule a consultation, fill out our contact form.